How to control the consistency during the use of white latex adhesive.
When using white latex adhesive, it also needs to be diluted. Sometimes it is thick, sometimes it is thin. Therefore, when using white latex adhesive, attention is also required to control the consistency of the white latex adhesive. So how should the consistency of white latex adhesive be controlled? Let's follow the white latex adhesive manufacturer to find out.

When performing production operations with white latex adhesive, it cannot be done at low temperatures. During use, the consistency of the latex should be determined according to actual needs. That is, the concentration can be diluted as needed, and water can be added. However, it is important to note that the temperature of the latex needs to be raised to 30 degrees, and water above 30 degrees should be slowly added to the latex, stirring evenly. Then it can be used. To prevent skin formation during use, a little water can be sprinkled on the surface. To speed up the curing rate, a little salt can be added.
When using white latex adhesive, it is very important to pay attention to its consistency. Therefore, it is necessary to control its concentration well, and the methods mentioned above should be mastered.