1. Pay attention to temperature. When using white latex adhesive, there are certain temperature requirements. If the temperature is too high or too low, bonding operations are not suitable. Generally, the minimum temperature should not be lower than 7 degrees Celsius, and the maximum temperature should not be higher than 95 degrees Celsius; otherwise, the bonding strength of the adhesive layer will decrease, or bonding may not be completed at all. In addition, if using clean water to dilute the white latex adhesive, you also need to pay attention to the surface temperature. Before dilution, ensure that the surface temperature of the white latex adhesive exceeds 30 degrees Celsius, and the temperature of the clean water added should also be above 30 degrees Celsius. Do not dilute with clean water below 10 degrees Celsius.

2. Pay attention to usage safety. Although high-quality white latex adhesive does not produce harmful substances during use and is an environmentally friendly product, it is ultimately a chemical material, so it is still necessary to avoid splashing into the eyes or accidental ingestion, as it can otherwise cause great harm to health. If a small amount of white latex adhesive is accidentally ingested or gets into the eyes, immediately rinse with plenty of clean water to minimize damage.

3. Pay attention to storage methods. White latex adhesive should be stored in a dry, cool environment. Generally, the temperature should not be lower than 5 degrees Celsius. In addition, for white latex adhesive that has been opened and used, if it cannot be used up at once, a layer of clean water needs to be sprinkled on its surface to prevent skin formation, and then the container should be tightly sealed for storage. Before using again, a small amount of hydrochloric acid can be added appropriately, then thoroughly stirred evenly before use.

In general, due to its special properties and characteristics, white latex adhesive has a very wide range of uses. However, there are still some precautions to pay attention to during use to avoid affecting the bonding effect. Also, because of the large market demand, low-quality white latex adhesive products are also relatively common at present, and counterfeit and shoddy products should also be avoided when purchasing.